Hey!!
Today I will teach you How to make an Electronics Dice.

Following picture is of Electronic Dice.We learn procedure of making Electronics Dice.

As you know that Dice is rolling thing which is used in a game.There is only one to six points on it which came randomly when we throw it.As that is a manually procedure which we convert it in electronically by using a button.
For this purpose we need some components.Components that are used in making of circuit of Dice.

Following components are needed for Electronic Dice.

So If we have all above components then we have to design its circuit.Circuit shows how we have to connect these components with each other.

Circuit Diagram of Electronics Dice is shown below.

In circuit two ICs, resistors,leds,button, diodes and power supply is required.
Before go on Hardware first we make its Simulation for check that,Is It working or not.For this purpose we used Proteus and place all the components as they are placed in circuit diagram in Proteus. Circuit of Proteus simulation shown below.

 Through simulation we verified our results,that this circuit is working or not.Once we verified that then we move toward its PCB designing.In Ares we make the PCB of above simulate circuit.After that we take a print of PCB design and then paste in on Copper Board. Then we pass it through further steps and get our final result in the form of Hardware of Electronics Dice.

This the procedure of making Electronic Dice.Please comment about this tutorial,It is helpful or not.If It is helpful then How and If It is not then How I can make further improvements to make It helpful for the others.

Stay Connect for other tutorials.