Today in this post I will be telling you about the 1st stage towards production process in 3D production houses,
So the 1st process is 3D modeling and it is very much unknown to a new people who recently know about it because all of them thinks that modeling means the fashion artist who used to ramp on stage and show their styles poses.
But today I am going to tell you that 3D modeling is the process of producing a model or a character through Computer. A model is a representation of the construction and working of some system of interest.
A model is similar to but simpler than the system it represents. One purpose of a model is to enable the analyst to predict the effect of changes to the system.
A model means anything which you like to make when you see it and nothing is impossible until unless you try. So modeling is a bit easier and a toughest also.

If you have lot of interest on it then you can definitely be a good modeler

On the one hand, a model should be a close approximation to the real system and incorporate most of its salient features. On the other hand, it should not be so complex that it is impossible to understand and experiment with it. A good model is a judicious tradeoff between realism and simplicity. Simulation practitioners recommend increasing the complexity of a model interactively.

An important issue in modeling is model validity. Model validation techniques include simulating the model under known input conditions and comparing model output with system output.